Rotary switch to change modes such as Edit Mode (to make and edit motions with ME) Automatic Mode (to play motion inputted automatically) Operating Mode (to control robot with wireless controller) and other functions. RPU-11 Processing Unit with ca ble, small screwdriver and wiring harness. This is the RPU-11 Processing Unit for the Futaba Humanoid Robot,
...more about the Futaba RPU-11 Processing Unit RBT-1
|
Controller is designed to turn off automatically if the controller is not in use for more than five minutes Vibration switch is located on the back of the transmitter One year limited warranty. Futaba RRCT-11 transmitter. This is the Futaba RRCT-11 2.4GHz Transmitter for the Futaba RBT-1
...more about the Futaba RRCT-11 Transmitter 2.4G RBT-1
|
Two LED lights on the receiver. One indicates the status of communication and the other on is red when there is power to the receiver. One year limited warranty. One Futaba RRCR-11 receiver for the robot. This is the Futaba RRCR-11 Receiver 2.4G fo r the RBT-1 Robot,
...more about the Futaba RRCR-11 Receiver 2.4G RBT-1
|
Karbonite construction. Karbonite gears are four times stronger than conventional white resin gears making them less likely to strip under the loads that would usually break standard gears. Replacement ball bearings included. Karbonite 1st, 2nd, 3r d and final gears, two steel pins, white spacer. This is the Karbonite Gear Set for the Hitec HSR-8498HB Robot Servo
...more about the Hitec Rcd HSR-8498HB Karbonite Gear Set
|
|
|
Direct replacement items Nylon construction Steel horn screws. One 8498 HA-1 horn. One 8498 HA-2 horn. One 8498 HB-1 horn. One 8498 HB-2 horn. Eight 2x5mm screws. Two 2.6x7.5mm screws. This is a replacement Servo Horn and Horn Screw Set from HiTec for use with with the HSR-8498HB robot servo found specifically on the
...more about the Hitec Rcd HSR-8498HB Servo Horn/Horn Screw Set
|
|
|
|
|
|
|
|
|
|
|
|
|